Waste toner cartridge cleaning residue

Need to pay attention to is: hair dryer blowing wipe toner box at the bottom of the toner residual, has a lot of toner dust flying and other equipment to prevent contamination, the operation should be as far as possible in the outdoors. In the toner cartridge after cleaning the toner cartridges around the toner also need to clean up.

Following the toner box and the waste toner waste toner residual cleared after, but also on the charging roller, magnetic roller waste powder residue to clean up, specific methods are as follows:

When charging roller and magnetic roller, the fixing screw of the charging roller and the magnetic roller must be found first, and the screw is screwed off with a screwdriver. The charging roller and the magnetic roller carefully removed from the cartridges. The two ends of the charging roller are provided with a plastic gear, and the gear at the two ends of the charging roller must be removed before wiping.

When cleaning, use cotton or soft cloth to clean up the waste powder on the charging roller. After cleaning the charging roller back into the cartridge, and screw down the screws at both ends.

Cartridge in after a period of time the use of toner will gradually decrease until completely exhausted, most people in toner after choose to add alternative toner, but many people but don't know cartridges in the replacement and not really the toner used up completely. Like the battery on the remote control car, although the car can not move but the battery is still used on the remote control. The toner cartridge is the same reason. So the cartridge in fc298 should pay special attention to clean up. If not clean, add toner and toner is possible because of the incompatibility and the formation of bulk solids.